Nails and screws

Only SPAX wood connector screws may be used to fasten the wood connectors to OSB and fibreboard (chipboard) – ideally in conjunction with our SPAX T-STAR bits. It is important to select screw length to ensure that the screw tip protrudes through the rear side of the board. 

 

Connector nails, on the other hand, are used where nails are subjected to pull-out and shear forces, for instance, for fastening wood connectors, in wood construction, carpentry shops or construction stores. They are hammered into wood like normal nails. However, they hold like screws – thanks to the conical shape below the flat head, which enables force-fitted, centric fastening. In many cases, SPAX wood connector screws can be used as an alternative to connector nails. This often presents the advantage of achieving a comparably higher load-bearing capacity – at least on steel plate thicknesses t ≥ 2 mm.

4 Products

Sorting
SPAX rafter nails SXCN
Rafter nail
  • Item number: R:1636_34581
Dimensions
Quantity
Universal screw, full thread, flat countersunk head, T-STAR plus, 4CUT, WIROX
Universal screw WIROX
  • Head Shape: Flat countersunk head
  • Surface: WIROX
  • Drive: T-STAR plus
  • Point: 4CUT
  • Item number: R:1636_10091
Dimensions
Quantity
Connector nails SXCN
Connector nail
  • Item number: R:1636_34582
Dimensions
Quantity
Wood connector screws SXCS
Joist hanger screw, WIROX
  • Item number: R:1636_34583
Dimensions
Quantity

SPAX nails and screws for wood connectors

SPAX wood connector screws can be used as a replacement for grooved nails. In many cases, a higher load-bearing capacity can be achieved compared to grooved nails (applies to sheet steel thicknesses t ≥ 2 mm). Only SPAX wood connector screws may be used to attach the wooden connectors to OSB and flat pressed boards (chipboard). Important: Choose screw length so that the screw tip protrudes on the back of the plate. For optimal use, we recommend our SPAX T-STAR Bits. 

Grooved nails are used where nails are stressed on pulling out and shearing. They are hammered into the wood like a nail, but hold like a screw. Under the flat head there is a conical attachment, whereby the hole in the connector is always fully filled when the nail is hammered in, thus creating a force-locked, centric attachment. Grooved nails are used for fastening wooden connectors, in timber construction, engineering timber construction, carpentry, construction shops, etc.



We help with the choice of screws

Find the right screw for your project – with our screw consultant

For every challenge, SPAX has a screw that is up to it:
Find exactly the fastener your project needs with our screw consultant.
With a few clicks you can find the right screw for your application.



We are here for you!

Do you have questions that can only be answered personally?
 

+49 2333 799-0
 

Or use our contact page